Chapter 5 245
Language Reference
HCOPy Subsystem
HCOPy Subsystem
The HCOPy subsystem controls the setup of plotting and printing to an external
device.
Abort the Print
:HCOPy:ABORt
Aborts hard copy printout of results.
Front Panel
Access:
ESC (with print in progress)
Printer Type
:HCOPy:DEVice:TYPE AUTO|CUSTom|NONE
:HCOPy:DEVice:TYPE?
Sets up the printer by selecting printer type.
AUTO - the instrument queries the printer to determine the printer type and
automatically sets itself for that printer
CUSTom - allows you to select a custom printer if your printer cannot be
auto-configured
NONE - tells the instrument that the hard copy output device is not a printer
Factory Preset
and *RST: The factory default is AUTO. This parameter is persistent,
which means that it retains the setting previously selected, even
through a power cycle.
Front Panel
Access:
Print Setup, Printer Type
Select Report Content
:HCOPy:EMI:ITEM:REPort:SCReen|SLISt|ISETups[:State]
|ON|OFF|1|0
:HCOPy:EMI:ITEM:REPort:SCReem|SLISt|ISETups[:State]?
Selection of report content: screen dump, signal list, and instrument setups.
Print Report
:HCOPy:EMI:REPort:IMMediate
Prints a report.
To Next Page
Loading...
Need help?
General
