To Next Page

To Previous Page

Chapter 5 213

Language Reference

CALCulate:LLINe Subsection

Merge Additional Values into the Existing Limit Line

:CALCulate:LLINe[1]|2:DATA:MERGe

<x-axis>,<ampl>,<connected>{,<x-axis>,<ampl>,<connected>}

Adds the points with the specified values to the current limit line, allowing you to

merge limit line data. Up to two amplitude values are allowed for each x value. If

too much data is merged, as many points as possible are merged into the existing

limit and then an error is reported. Up to 200 points total may be defined for each

limit.

• <x-axis> can be frequency or time values as specified by

:CALCulate:LLINe:CONTrol:DOMain. Frequencies are always in Hz.

Time is always in seconds. No unit is allowed in this parameter.

• <ampl> – amplitude values are in the current Y-axis units. No unit is allowed in

this parameter.

• <connected> connected values are either 0 or 1. A 1 means this point should be

connected to the previously defined point to define the limit line. A 0 means

that it is a point of discontinuity and is not connected to the preceding point.

The “connected” value is ignored for the first point.

Range: <x-axis> –30 Gs to +30 Gs for time limits

<x-axis> –30 GHz to +350 GHz for frequency limits

<ampl> –120 dBm to +100 dBm

<connected> 0 or 1

Front Panel

Access:

Display, Limits, X Axis Units Freq Time

Delete Limit Line

:CALCulate:LLINe[1]|2:DELete

Deletes the selected limit line.

Display the Limit Line

:CALCulate:LLINe[1]|2:DISPlay OFF|ON|0|1

:CALCulate:LLINe[1]|2:DISPlay?

Controls the display of the current limit line.

Factory Preset

and *RST: Off

Front Panel

Access:

Display, Limits, Limit 1|2, Limit On Off

Agilent Technologies EMC Series Programmer's Guide

Other manuals for Agilent Technologies EMC Series