Agilent Technologies EMC Series Programmer's Guide

226 Chapter 5
Language Reference
CALCulate:MARKer Subsection
Delta Pair Markers Stop Frequency X Position
:CALCulate:MARKer[1]|2|3|4:X:POSition:STOP <param>
:CALCulate:MARKer[1]|2|3|4:X:POSition:STOP?
Position the right-most marker, the stop frequency of the designated band-type
marker pair, at the specified trace X position. Use :CALCulate:MARKer:MODE
BAND to select band markers.
The query returns the current X position stop frequency of the designated marker.
Range: Refer to the [:SENSe]:SWEep:POINts command.
Front Panel
Access:
Marker, <active marker>, Delta
Marker X-Axis Readout
:CALCulate:MARKer[1]|2|3|4:X:READout
FREQuency|TIME|ITIMe|PERiod
:CALCulate:MARKer[1]|2|3|4:X:READout?
Selects the units for the x-axis readout of the marker. Available units are:
Frequency
Time
Inverse of time
Period
Factory Preset
and *RST: Frequency
Front Panel
Access:
Marker, Readout, Frequency
Marker, Readout, Time
Marker, Readout, Inverse Time
Marker, Readout, Period
Span Markers Span X Value
:CALCulate:MARKer[1]|2|3|4:X:SPAN <param>
:CALCulate:MARKer[1]|2|3|4:X:SPAN?
Change the frequency span of the designated span-type marker pair to position the
markers at the desired trace X values. The value is in the X-axis units (which is
usually frequency or time). Use :CALCulate:MARKer:MODE SPAN to select
span markers.
The query returns the current X value frequency span of the designated markers. If
span markers are not selected, the query returns the latest marker reading as a span
(always positive).

Agilent Technologies EMC Series Specifications

General

Brand	Agilent Technologies
Model	EMC Series
Category	Measuring Instruments
Language	English