Agilent Technologies G1313A User Manual

267
Introduction to the Control Module
Diagnostics and Tests
Change Needle,
Piston and Arm
Use the F2 key (Change) to start the maintenance procedures for changing
the autosampler needle, piston and gripper arm.
Signals Use the F8 key (Signals) to display the signals available from the ALS
thermostat. Press F6 key (Setup). Here you can select which signals are
shown.

Agilent Technologies G1313A Specifications

General

Brand	Agilent Technologies
Model	G1313A
Category	Laboratory Equipment
Language	English