7-50 i3070 Series 5i Help
Zone 2 Conveyor Motor (Movable Side)
Removal
1 Follow the Removal instructions in Zone 2 Conveyor Belt (Movable Side)
to remove the belt on the movable side of the Zone 2 conveyor.
2 Remove the four mounting screws securing the conveyor motor.
3 Loosen the two setscrews that mount the pulley on the conveyor motor
and remove the pulley.
Installation
1 Install the pulley and tighten the setscrews. Ensure that the pulley is
properly aligned.
2 Align the mounting holes and secure the new conveyor motor with four
screws.
3 Follow the Installation instructions in Zone 2 Conveyor Belt (Movable
Side) to complete the installation.
Access setscrews from the side
Conveyor Motor
Setscrew
Motor Pulley
Zone 2 Conveyor Assembly
To Next Page
Loading...
