Agilent Technologies Medalist i3070 5i Series - Zone 1 Conveyor: Bevel Gears and Chain

Maintenance
i3070 Series 5i Help 5-9
Zone 1 Conveyor: Bevel Gears and Chain
1 Open the rear door to access the Zone 1 conveyor assembly.
2 Remove three screws to remove the rear cover of the assembly.
3 Use a brush to lightly apply grease to the two bevel gears and the
chain.
4 Replace the rear cover.
5 Close the rear door.
Zone 1 Conveyor Assembly
Rear Cover
Screw
Chain
Bevel Gears
Top View