3-10 i3070 Series 5i Help
Test Development
ID Block
The main function of the ID block is to provide the fixture ID for the top
fixture. The fixture ID signal (pin 5 to 12 in the first two rows) is used to
verify that the top and bottom fixtures match, before the system can go
into Production Auto mode.
The ID block has three groups of 16 pins arranged in two rows each, for a
total of 48 pins. Table 3- 2 shows the pin assignments. The first two rows
of pins cannot be reassigned. Rows 3 and 4 (VTEP) and rows 5 and 6
(CET) can be changed.
Figure 3-9 ID Block
Table 3- 1 ID Block: Pinouts
161412108642
15131197531
161412108642
15131197531
161412108642
15131197531
To Next Page
Loading...
