Page 99
aero Flight Mode menu
Aileron to Rudder Mixing
The Aileron to Rudder Mixing function allows you to mix a percentage of rudder control with aileron control. When you move the
ailerons right and left, the rudder will move right and left. The Aileron to Rudder Mixing function is typically used on many high
wing or scale models to automatically make coordinated turns. The amount and the direction that the rudder moves with aileron
control is adjusted by changing the Aileron
4
rudder mixing percentage value either positive or negative.
IMPORTANT The Aileron to Rudder Mixing function must be assigned to a Switch Position Number before it can be
Activated. For more information, see page 45.
2) Press the Navigation Pad
6
to highlight AI
4
RU, then press the
ENTER key to display the AI
4
RU menu. The cursor will default to
COMMON>COM.
3) Press the YES/+ or NO/- keys to choose the desired COM or SEP
option as described previously.
4) Press the Navigation Pad
6
to highlight AI
4
RU>0%.
5) Press the YES/+ or NO/- keys to change the Aileron
4
Rudder mixing
percentage value.
AI
4
RU setting range is -100% to 100%. The default setting is 0%. When the percentage value is increased from 0% to 100%,
rudder travel will increase in one direction in relation to aileron travel. When the percentage value is decreased from
0% to -100%, rudder travel will increase in the opposite direction in relation to aileron travel.
The Aileron
4
Rudder mixing percentage value is a ratio of rudder
travel to aileron travel. For example, when the Aileron
4
Rudder
mixing percentage value is set to 10%, the rudder will travel 1/10th the
amount that the ailerons travel. This mix is Linear.
1) Press the Navigation Pad
56
to highlight MIXING, then press the ENTER key to display the MIXING menu. The FLAPERON
sub-menu will be highlighted by default.
Throttle to Elevator Mixing
The Throttle to Elevator Mixing function allows you to mix a percentage of elevator control with throttle control. When you
increase the throttle, the elevator will move up or down. The Throttle to Elevator Mixing function is typically used on scale aircraft
to reduce minor pitch changes when increasing or decreasing power. The amount and the direction that the elevator moves when
you increase the throttle is adjusted by changing the Throttle
4
Elevator mixing percentage value either positive or negative.
IMPORTANT The Throttle to Elevator Mixing function must be assigned to a Switch Position Number before it can be
Activated. For more information, see page 45.
1) Press the Navigation Pad
56
to highlight MIXING, then press the ENTER key to display the MIXING menu. The FLAPERON
sub-menu will be highlighted by default.
2) Press the Navigation Pad
6
to highlight TH
4
EL, then press the
ENTER key to display the TH
4
EL menu. The cursor will default to
COMMON>COM.
3) Press the YES/+ or NO/- keys to choose the desired COM or SEP
option as described previously.
AERO
To Next Page
Loading...
