VLL Service Configuration Commands
Page 196 7210 SAS-X, R6 OS Services Guide
Generic Commands
shutdown
Syntax [no] shutdown
Context config>service>epipe
config>service>epipe>sap
config>service>epipe>sap>eth-cfm>mep
Description This command administratively disables an entity. When disabled, an entity does not change, reset, or
remove any configuration settings or statistics.
The operational state of the entity is disabled as well as the operational state of any entities contained
within. Many objects must be shut down before they may be deleted.
Services are created in the administratively down (shutdown) state. When a no shutdown command
is entered, the service becomes administratively up and then tries to enter the operationally up state.
Default administrative states for services and service entities is described below in Special Cases.
The no form of this command places the entity into an administratively enabled state.
description
Syntax description description-string
no description
Context config>service>epipe
config>service>epipe>sap
config>service>epipe>spoke-sdp
config>connection-profile
Description This command creates a text description stored in the configuration file for a configuration context.
The description command associates a text string with a configuration context to help identify the
content in the configuration file.
The no form of this command removes the string from the configuration.
Default No description associated with the configuration context.
Parameters string — The description character string. Allowed values are any string up to 80 characters long
composed of printable, 7-bit ASCII characters. If the string contains special characters (#, $,
spaces, etc.), the entire string must be enclosed within double quotes.
eth-cfm
Syntax eth-cfm
Context config>service>vpls
To Next Page
Loading...
