Virtual Leased Line Services
7210 SAS-X, R6 OS Services Guide Page 197
config>service>vpls>mesh-sdp
config>service>vpls>spoke-sdp
config>service>vll>sap
Description This command enables the context to configure ETH-CFM parameters.
mep
Syntax mep mep-id domain md-index association ma-index [direction {up | down}]
no mep mep-id domain md-index association ma-index
Context config>service>epipe>sap>eth-cfm
Description This command provisions the maintenance endpoint (MEP).
The no form of the command reverts to the default values.
Note: For more information on ETH-CFM support for different services, see Table 13, “ETH-CFM
Support Matrix for 7210 SAS-X Devices,” on page 102.
Parameters mep-id — Specifies the maintenance association end point identifier.
Values 1 — 8191
md-index — Specifies the maintenance domain (MD) index value.
Values 1 — 4294967295
ma-index — Specifies the MA index value.
Values 1 — 4294967295
direction up| down — Indicates the direction in which the maintenance association (MEP) faces on
the bridge port. Direction is not supported when a MEP is created directly under the vpls>eth-
cfm construct (vMEP).
down — Sends ETH-CFM messages away from the MAC relay entity.
up — Sends ETH-CFM messages towards the MAC relay entity.
To Next Page
Loading...
