Alcatel-Lucent 7210 SAS-X - Page 205

Virtual Leased Line Services
7210 SAS-X, R6 OS Services Guide Page 205
VLL SAP Commands
sap
Syntax sap sap-id [no-endpoint] [create] < with-aggregate-meter >
sap sap-id endpoint endpoint-name [create]
no sap sap-id
Context config>service>epipe
Description This command creates a Service Access Point (SAP) within a service. A SAP is a combination of port
and encapsulation parameters which identifies the service access point on the interface and within the
. Each SAP must be unique.
All SAPs must be explicitly created. If no SAPs are created within a service or on an IP interface, a
SAP will not exist on that object.
Enter an existing SAP without the create keyword to edit SAP parameters. The SAP is owned by the
service in which it was created.
In a single physical port only one SAP can belong to one service. Multiple SAPs can be defined over
a physical port but each of these SAPs should belong to different service.
A SAP can only be associated with a single service. A SAP can only be defined on a port that has
been configured as an access port.
If a port is shutdown, all SAPs on that port become operationally down. When a service is shutdown,
SAPs for the service are not displayed as operationally down although all traffic traversing the service
will be discarded.
The operational state of a SAP is relative to the operational state of the port on which the SAP is
defined.
The following are supported:
• Ethernet SAPs support null, dot1q
The no form of this command deletes the SAP with the specified port. When a SAP is deleted, all
configuration parameters for the SAP will also be deleted.
Default No SAPs are defined.
Special Cases A default SAP has the following format: port-id:*. This type of SAP is supported only on Ethernet
MDAs and its creation is allowed only in the scope of Layer 2 services (Epipe and VPLS).
sap-id — Specifies the physical port identifier portion of the SAP. See Common CLI Command
Descriptions on page 925 for command syntax.
with-aggregate-meter — This parameter is supported only for 7210 SAS-X for releases prior to
R3.0r1.
This parameter is specified during SAP creation if the aggregate-meter-command is used for the
SAP.
A limited set of hardware resources are available for SAPs that intend to use the aggregate
meters.