VLL Service Configuration Commands
Page 206 7210 SAS-X, R6 OS Services Guide
endpoint — Adds a SAP endpoint association.
no endpoint — removes the association of a SAP with an explicit endpoint name.
create — Keyword used to create a SAP instance. The create keyword requirement can be enabled/
disabled in the environment>create context.
agg-rate-limit
Syntax agg-rate-limit agg-rate
no agg-rate-limit
Context config>service>epipe>sap>egress
Description This command defines a maximum total rate for all egress queues on a service SAP.
The SAP aggregate rate can be used only if SAP based scheduling mode is configured at the port
level. It is not supported in FC-based scheduling mode.
When configured in SAP-based scheduling mode, the egress port scheduler distributes the available
bandwidth to all the SAPs configured on the port, up to the configured aggregate rate for the SAP.
The no form of the command removes the aggregate rate limit from the SAP.
Parameters agg-rate — Defines the rate, in kilobits-per-second, that the maximum aggregate rate the queues on
the SAP or MSS can operate.
Values 1 — 40000000, max
tod-suite
Syntax tod-suite tod-suite-name
no tod-suite
Context config>service>epipe>sap
Description This command applies a time-based policy (filter or QoS policy) to the service SAP. The suite name
must already exist in the config>cron context.
Default no tod-suite
Parameters tod-suite-name — Specifies collection of policies (ACLs, QoS) including time-ranges that define the
full or partial behavior of a SAP. The suite can be applied to more than one SAP.
accounting-policy
Syntax accounting-policy acct-policy-id
no accounting-policy
Context config>service>epipe>sap
To Next Page
Loading...
