Virtual Leased Line Services
7210 SAS-X, R6 OS Services Guide Page 221
2. Change the counter-mode to the desired value, execute the command config>service>epipe/
vpls>sap>counter-mode {in-out-profile-count| forward-drop-count}.
3. Execute the command config>service>epipe/vpls>sap> collect-stats, to enable writing of
accounting records.
The no form of the command restores the counter mode to the default value.
Default when either in-out-profile-count or forward-drop-count is in use in-out-profile-count
Parameters forward-drop-count — If the counter mode is specified as "forward-drop-count", one counter
counts the forwarded packets and octets received on ingress of a SAP and another counts the
dropped packets. The forwarded count is the sum of in-profile and out-of-profile packets/octets
received on SAP ingress. The dropped count is count of packets/octets dropped by the policer. A
packet is determined to be in-profile or out-of-profile based on the meter rate parameters
configured. A packet is dropped by the policer if it exceeds the configured PIR rate. The in-
profile count and out-of-profile count is not individually available when operating in this mode.
in-out-profile-count — If the counter mode is specified as "in-out-profile-count", one counter counts
the total in-profile packets and octets received on ingress of a SAP and another counts the total
out-of-profile packets and octets received on ingress of a SAP. A packet is determined to be in-
profile or out-of-profile based on the meter rate parameters configured. A packet is dropped by
the policer if it exceeds the configured PIR rate. Dropped counts are not maintained in hardware
when this mode is used. It is obtained by subtracting the sum of in-profile count and out-of-
profile count from the total SAP ingress received count and displayed.
To Next Page
Loading...
