VLL Service Configuration Commands
Page 220 7210 SAS-X, R6 OS Services Guide
By default, if no specific QoS policy is associated with the SAP for ingress, so the default QoS policy
is used.
The no form of this command removes the QoS policy association from the SAP, and the QoS policy
reverts to the default.
policy-id — The ingress policy ID to associate with SAP on ingress. The policy ID must already exist.
Values 1 — 65535
statistics
Syntax statistics
Context config>service>epipe>sap
config>service>vpls>sap
Description This command enables the context to configure the counters associated with SAP ingress and egress.
ingress
Syntax ingress
Context config>service>epipe>sap>statistics
config>service>vpls>sap>statistics
Description This command enables the context to configure the ingress SAP statistics counter.
counter-mode
Syntax counter-mode {in-out-profile-count| forward-drop-count}
Context config>service>epipe>sap>statistics>ingress
config>service>vpls>sap>statistics>ingress
Description This command allows the user to set the counter mode for the counters associated with sap ingress
meters (a.ka. policers). A pair of counters is available with each meter. These counters count different
events based on the counter mode value.
Note: The counter mode can be changed if an accounting policy is associated with a SAP. If the
counter mode is changed the counters associated with the meter are reset and the counts are cleared. If
an accounting policy is in use when the counter-mode is changed a new record will be written into the
current accounting file.
Note: The configuration information is not saved across re-boot.
Execute the following sequence of commands to ensure a new accounting file is generated when the
counter-mode is changed:
1. Execute the command config>service>epipe/vpls>sap> no collect-stats, to disable writing of
accounting records.
To Next Page
Loading...
