Alcatel-Lucent 7210 SAS-X - Page 219

Virtual Leased Line Services
7210 SAS-X, R6 OS Services Guide Page 219
config>service>vpls>sap>ingress>meter-override>meter
config>service>ies>interface>sap>ingress>meter-override>meter
config>service>vprn>interface>sap>ingress>meter-override>meter
Description This command within the SAP ingress meter-overrides contexts is used to override the sap-ingress
QoS policy configured rate parameters for the specified meter-id.
The no rate command is used to restore the policy defined metering and profiling rate to a meter.
Default max — The max default specifies the amount of bandwidth in kilobits per second (thousand bits per
second). The max value is mutually exclusive to the pir-rate value.
Parameters pir-rate — Defines the administrative PIR rate, in kilobits, for the queue. When the rate command is
executed, a valid PIR setting must be explicitly defined. When the rate command has not been
executed, the default PIR of max is assumed.
Fractional values are not allowed and must be given as a positive integer.
NOTE: When the meter mode is set to 'trtcm2' the PIR value is interpreted as the EIR value. For
more information, see the 7210 SAS QoS user guide.
The actual PIR rate is dependent on the queue’s adaptation-rule parameters and the actual
hardware where the queue is provisioned.
Values [0..20000000 | max]
Default max
cir-rate — The cir parameter overrides the default administrative CIR used by the queue. When the
rate command is executed, a CIR setting is optional. When the rate command has not been
executed or the cir parameter is not explicitly specified, the default CIR (0) is assumed.
Fractional values are not allowed and must be given as a positive integer.
Values [0..20000000 | max]
Default 0
qos
Syntax qos policy-id
no qos
Context config>service>epipe>sap>ingress
Description This command associates a Quality of Service (QoS) policy with an ingress Service Access Point
(SAP).
QoS ingress policies are important for the enforcement of SLA agreements. The policy ID must be
defined prior to associating the policy with a SAP or IP interface. If the policy-id does not exist, an
error will be returned.
The qos command is used to associate ingress . The qos command only allows ingress policies to be
associated on SAP ingress. Attempts to associate a QoS policy of the wrong type returns an error.
Only one ingress QoS policy can be associated with a SAP or IP interface at one time. Attempts to
associate a second QoS policy of a given type will return an error.