Alcatel-Lucent 7210 SAS-X - Page 218

VLL Service Configuration Commands
Page 218 7210 SAS-X, R6 OS Services Guide
mbs
Syntax mbs size-in-kbits
no mbs
Context config>service>epipe>sap>ingress>meter-override>meter
config>service>vpls>sap>ingress>meter-override>meter
config>service>ies>interface>sap>ingress>meter-override>meter
config>service>vprn>interface>sap>ingress>meter-override>meter
Description This command, within the SAP ingress meter-overrides contexts, is used to override the sap-ingress
QoS policy configured mbs parameter for the specified meter-id.
The no form of the command is used to restore the meter mbs setting to the meter defined value.
Default no mbs
Parameters size-in-kbits — The size parameter is required when specifying mbs override and is expressed as an
integer representing the required size in either bytes or kilobytes. The default is kilobytes. The
optional byte and kilobyte keywords are mutually exclusive and are used to explicitly define
whether size represents bytes or kilobytes. When byte is defined, the value given for size is
interpreted as the meter MBS value given in bytes. When kilobytes is defined, the value is
interpreted as the meter MBS value given in kilobytes.
Values [4..2146959 | default]
mode
Syntax mode mode
no mode
Context config>service>epipe>sap>ingress>meter-override>meter
config>service>vpls>sap>ingress>meter-override>meter
config>service>ies>interface>sap>ingress>meter-override>meter
config>service>vprn>interface>sap>ingress>meter-override>meter
Description This command within the SAP ingress meter-overrides contexts is used to override the sap-ingress
QoS policy configured mode parameters for the specified meter-id.
The no mode command is used to restore the policy defined metering and profiling mode to a meter.
Parameters mode — Specifies the rate mode of the meter-override.
Values trtcm1|trtcm2|srtcm
rate
Syntax rate cir cir-rate [pir pir-rate]
no rate
Context config>service>epipe>sap>ingress>meter-override>meter