Virtual Leased Line Services
7210 SAS-X, R6 OS Services Guide Page 217
the constraint used when deriving the operational PIR for the queue. When the meter-override
command is not specified, the default applies.
NOTE: When the meter mode in use is 'trtcm2', this parameter is interpreted as EIR value. For
more information, see the description and relevant notes for meter modes in the 7210 SAS QoS
user guide.
cir — The cir parameter defines the constraints enforced when adapting the CIR rate defined within
the meter-override meter meter-id command. The cir parameter requires a qualifier that defines
the constraint used when deriving the operational CIR for the queue. When the cir parameter is
not specified, the default constraint applies.
adaptation-rule — Specifies the criteria to use to compute the operational CIR and PIR values for this
meter, while maintaining a minimum offset.
Values max — The max (maximum) keyword is mutually exclusive with the min and
closest options. When max is defined, the operational PIR for the meter will be
equal to or less than the administrative rate specified using the meter-override
command.
min — The min (minimum) keyword is mutually exclusive with the max and
closest options. When min is defined, the operational PIR for the queue will be
equal to or greater than the administrative rate specified using the meter-override
command.
closest — The closest parameter is mutually exclusive with the min and max
parameter. When closest is defined, the operational PIR for the meter will be the
rate closest to the rate specified using the meter-override command.
cbs
Syntax cbs size-in-kbytes
no cbs
Context config>service>epipe>sap>ingress>meter-override>meter
config>service>vpls>sap>ingress>meter-override>meter
config>service>ies>interface>sap>ingress>meter-override>meter
config>service>vprn>interface>sap>ingress>meter-override>meter
Description This command, within the SAP ingress meter-overrides contexts, is used to override the sap-ingress
QoS policy configured cbs parameter for the specified meter-id.
The no form of the command is used to restore the meter cbs setting to the meter defined value.
Default no mbs
Parameters size-in-kbytes — The size parameter is an integer expression of the number of kilobytes reserved for
the meter. If a value of 10KBytes is desired, enter the value 10. A value of 0 specifies that no
reserved buffers are required by the queue (a minimal reserved size can still be applied for
scheduling purposes).
Values [4..2146959 | default]
To Next Page
Loading...
