Virtual Leased Line Services
7210 SAS-X, R6 OS Services Guide Page 225
Context config>service>epipe>spoke-sdp
Description This command
spe
cifies the precedence of the SDP binding when there are multiple SDP bindings
attached to one service endpoint. The value of zero can only be assigned to one SDP bind making it
the primary SDP bind. When an SDP binding goes down, the next highest precedence SDP binding
will begin to forward traffic.
The no form of the command returns the precedence value to the default.
Default 4
Parameters precedence-value — Specifies the spoke SDP precedence.
Values 1 — 4
primary — Specifies to make this the primary spoke SDP.
pw-path-id
Syntax [no] pw-path-id
Context config>service>epipe>spoke-sdp
Description Platforms Supported: 7210 SAS-T and 7210 SAS-R6.
This command enables the context to configure an MPLS-TP Pseudowire Path Identifier for a spoke-
sdp. All elements of the PW path ID must be configured in order to enable a spoke-sdp with a PW
path ID.
For an IES or VPRN spoke-sdp, the pw-path-id is only valid for ethernet spoke-sdps.
The pw-path-id only configurable if all of the following is true:
• The system is using network chassis mode D
• SDP signaling is off
• control-word is enabled (control-word is disabled by default)
• the service type is epipe, vpls, cpipe, or IES/VPRN interface
• mate SDP signaling is off for vc-switched services
The no form of the command deletes the PW path ID.
Default no pw-path-id
agi
Syntax agi agi
no agi
Context config>service>epipe>spoke-sdp>pw-path-id
Description Platforms Supported: 7210 SAS-T and 7210 SAS-R6.
This command configures the attachment group identifier for an MPLS-TP PW.
To Next Page
Loading...
