VLL Service Configuration Commands
Page 228 7210 SAS-X, R6 OS Services Guide
as the remote signaled dot1q value for the binding. The provisioned local dot1q tag must be stored as
the administrative dot1q value for the binding.
When the dot1q tag is not defined, the default value of zero is stored as the administrative dot1q
value. Setting the value to zero is equivalent to not specifying the value.
The no form of this command disables the command
Default no vlan-vc-tag
Parameters 0..4094 — Specifies a valid VLAN identifier to bind an 802.1Q VLAN tag ID.
To Next Page
Loading...
