Alcatel-Lucent 7210 SAS-X - Page 227

Virtual Leased Line Services
7210 SAS-X, R6 OS Services Guide Page 227
Values 1 — 4294967295
pw-status-signaling
Syntax [no] pw-status-signaling
Context config>service>epipe>spoke-sdp
Description Platforms Supported: 7210 SAS-T and 7210 SAS-R6.
This command enables pseudowire status signaling for this spoke SDP binding.
The no form of the command disables the status signaling.
Default pw-status-signaling
vc-label
Syntax [no] vc-label vc-label
Context config>service>epipe>spoke-sdp>egress
Description This command configures the egress VC label.
Parameters vc-label — A VC egress value that indicates a specific connection.
Values 16 — 1048575
vc-label
Syntax [no] vc-label vc-label
Context config>service>epipe>spoke-sdp>ingress
Description This command configures the ingress VC label.
Parameters vc-label — A VC ingress value that indicates a specific connection.
Values 2048 — 18431
vlan-vc-tag
Syntax vlan-vc-tag 0..4094
no vlan-vc-tag [0..4094]
Context config>service>epipe>spoke-sdp
Description This command specifies an explicit dot1q value used when encapsulating to the SDP far end. When
signaling is enabled between the near and far end, the configured dot1q tag can be overridden by a
received TLV specifying the dot1q value expected by the far end. This signaled value must be stored