Virtual Private LAN Services
Page 414 7210 SAS-X, R6 OS Services Guide
Default no send-queries
group
Syntax [no] group grp-address
Context config>service>vpls>sap>igmp-snooping>static
config>service>vpls>spoke-sdp>snooping>static
config>service>vpls>mesh-sdp>snooping>static
Description This command adds a static multicast group either as a (*, g) or as one or more (s,g) records. When a
static IGMP group is added, multicast data for that (*,g) or (s,g) is forwarded to the specific SAP or
SDP without receiving any membership report from a host.
Default none
Parameters grp-address — Specifies an IGMP multicast group address that receives data on an interface. The IP
address must be unique for each static group.
starg
Syntax [no] starg
Context config>service>vpls>sap>igmp-snooping>static>group
config>service>vpls>spoke-sdp>igmp-snooping>static>group
config>service>vpls>mesh-sdp>igmp-snooping>static>group
Description This command adds a static (*,g) entry to allow multicast traffic for the corresponding multicast
group from any source. This command can only be enabled if no existing source addresses for this
group are specified.
The no form of the command removes the starg entry from the configuration.
Default no starg
static
Syntax static
Context config>service>vpls>sap>igmp-snooping
config>service>vpls>spoke-sdp>igmp-snooping
config>service>vpls>mesh-sdp>igmp-snooping
Description This command enables access to the context to configure static group addresses. Static group
addresses can be configured on a SAP or SDP. When present either as a (*, g) entry, multicast packets
To Next Page
Loading...
