Virtual Private LAN Services
7210 SAS-X, R6 OS Services Guide Page 415
matching the configuration will be forwarded even if no join message was registered for the specific
group.
Default none
version
Syntax version version
no version
Context config>service>vpls>sap>igmp-snooping
config>service>vpls>mesh-sdp>igmp-snooping
config>service>vpls>spoke-sdp>igmp-snooping
config>service>pw-template>igmp-snooping
Description This command specifies the version of IGMP which is running on this SAP or SDP. This object can
be used to configure a router capable of running either value. For IGMP to function correctly, all
routers on a LAN must be configured to run the same version of IGMP on that LAN.
When the send-query command is configured, all type of queries generate ourselves are of the
configured version. If a report of a version higher than the configured version is received, the report
gets dropped and a new “wrong version” counter is incremented.
If the send-query command is not configured, the version command has no effectThe version used
on that SAP orwill be the version of the querier.
Parameters version — Specify the IGMP version.
to-sap
Syntax to-sap sap-id
no to-sap
Context config>service>vpls>sap>igmp-snooping>mvr
Description
This command configures the SAP to which the multicast data needs to be copied.
In some scenarios, the multicast traffic should not be copied from the MVR VPLS to the SAP on
which the IGMP message was received (standard MVR behaviour) but to another SAP.
Default no to-sap
Parameters sap-id — Specifies the SAP to which multicast channels should be copied.
To Next Page
Loading...
