Alcatel-Lucent 7210 SAS-X - Page 457

VLL Show Commands
7210 SAS-X, R6 OS Services Guide Page 457
Sample Output
*A:Dut-A>show>service>id# all
Type
Indicates whether this Service SDP binding is a spoke or a mesh.
Admin Path MTU
The desired largest service frame size (in octets) that can be transmitted
through this SDP to the far-end router, without requiring the packet to be
fragmented.
Oper Path MTU
The actual largest service frame size (in octets) that can be transmitted
through this SDP to the far-end router, without requiring the packet to be
fragmented.
Delivery
Specifies the type of delivery used by the SDP: MPLS.
Admin State
The administrative state of this SDP.
Oper State
The operational state of this SDP.
Jitter Buffer
(packets)
Indicates the jitter buffer length in number of packet buffers.
Playout Threshold
(packets)
Indicates the playout buffer packets threshold in number of packet buf-
fers.
Playout Threshold
(packets)
Indicates the current packet depth of the jitter buffer.
Peer Pw Bits
Indicates the bits set by the LDP peer when there is a fault on its side of
the pseudowire. LAC failures occur on the SAP that has been configured
on the pipe service, PSN bits are set by SDP-binding failures on the pipe
service. The pwNotForwarding bit is set when none of the above failures
apply, such as an MTU mismatch failure. This value is only applicable if
the peer is using the pseudowire status signalling method to indicate
faults.
pwNotForwarding — Pseudowire not forwarding
lacIngressFault Local — Attachment circuit RX fault
lacEgresssFault Local — Attachment circuit TX fault
psnIngressFault Local — PSN-facing PW RX fault
psnEgressFault Local — PSN-facing PW TX fault
pwFwdingStandby — Pseudowire in standby mode
Signaling Over-
ride
Indicates the overriding signaled pseudowire type, as configured under
the signaled-vc-type-override option for Apipes. This field is only dis-
played if signaled-vc-type-override is configured.
LLF Admin State
Displays the Link Loss Forwarding administrative state.
LLF Oper State
Displays the Link Loss Forwarding operational state.
Standby Signaling
Master
Indicates if the parameter standby signalling master is enabled.
Label Description (Continued)