Alcatel-Lucent 7210 SAS-X - Page 522

Show, Clear, Debug Commands
Page 522 7210 SAS-X, R6 OS Services Guide
arp
Syntax arp [ip-address] | [mac ieee-address] | [sap sap-id] | [interface ip-int-name]
Context show>service>id
Description This command displays the ARP table for the VPLS instance. The ARP entries for a subscriber
interface are displayed uniquely. Each MAC associated with the subscriber interface child group-
interfaces is displayed with each subscriber interface ARP entry for easy lookup.
Parameters ip-address — All IP addresses.
mac ieee-address — Displays only ARP entries in the ARP table with the specified 48-bit MAC
address. The MAC address is in the form aa:bb:cc:dd:ee:ff or aa-bb-cc-dd-ee-ff, where aa, bb, cc,
dd, ee and ff are hexadecimal numbers.
Default All MAC addresses.
sap sap-id — Displays SAP information for the specified SAP ID.
interface — Specifies matching service ARP entries associated with the IP interface.
ip-address — The IP address of the interface for which to display matching ARP entries.
Values 1.0.0.0 — 223.255.255.255
ip-int-name — The IP interface name for which to display matching ARPs.
Output Show Service-ID ARP — The following table describes show service-id ARP output fields.
base
Syntax base [msap]
Context show>service>id
Description This command displays basic information about the service ID including service type, description,
SAPs and SDPs.
Label Description
IP Address
The IP address.
MAC Address
The specified MAC address.
Type Static — FDB entries created by management.
Learned — Dynamic entries created by the learningprocess.
Other — Local entries for the IP interfaces created.
Expiry
The age of the ARP entry.
Interface
The interface applied to the service.
SAP
The SAP ID.