Alcatel-Lucent 7210 SAS-X - Page 523

VPLS Show Commands
7210 SAS-X, R6 OS Services Guide Page 523
Output Show Service-ID Base — The following table describes show service-id base output fields:
Sample Output
*A:7210SAS# show service id 10 base
===============================================================================
Service Basic Information
===============================================================================
Service Id : 10 Vpn Id : 0
Service Type : VPLS
Name : (Not Specified)
Description : (Not Specified)
Customer Id : 1
Last Status Change: 02/06/2106 06:28:12
Last Mgmt Change : 01/10/1970 01:55:31
Admin State : Down Oper State : Down
MTU : Not Applicable Def. Mesh VC Id : 10
SAP Count : 0
Uplink Type: : L2
SAP Type: : Dot1q Range Customer vlan: : n/a
Label Description
Service Id The service identifier.
Service Type
Displays the type of service.
Description
Generic information about the service.
Customer Id
The customer identifier.
Last Mgmt Change
The date and time of the most recent management-initiated change to
this customer.
Adm
The administrative state of the service.
Oper
The operational state of the service.
Mtu
The largest frame size (in octets) that the can handle.
Adm
The largest frame size (in octets) that the SAP can handle.
SAP Count
The number of SAPs defined on the service.
SAP Type
The type of SAPs allowed in the service. It also describes the applied
processing by the node to the packets received on these SAPs.
Identifier
Specifies the service access (SAP).
OprMTU
Specifies the actual largest service frame size (in octets) that can be
transmitted through this , without requiring the packet to be fragmented.
Opr
The operating state of the SAP