Alcatel-Lucent 7210 SAS-X - Page 562

Show, Clear, Debug Commands
Page 562 7210 SAS-X, R6 OS Services Guide
Parameters endpoint-name — Specifies an endpoint name created in the config>service>vpls context.
Sample Output
*A:Dut-B# show service id 1 endpoint
===============================================================================
Service 1 endpoints
===============================================================================
Endpoint name : mcep-t1
Description : (Not Specified)
Revert time : 0
Act Hold Delay : 0
Ignore Standby Signaling : false
Suppress Standby Signaling : false
Block On Mesh Fail : true
Psv Mode Active : No
Tx Active : 231:1
Tx Active Up Time : 0d 00:06:57
Revert Time Count Down : N/A
Tx Active Change Count : 5
Last Tx Active Change : 02/13/2009 22:08:33
-------------------------------------------------------------------------------
Members
-------------------------------------------------------------------------------
Spoke-sdp: 221:1 Prec:1 Oper Status: Up
Spoke-sdp: 231:1 Prec:2 Oper Status: Up
===============================================================================
*A:Dut-B#