Alcatel-Lucent 7210 SAS-X - Page 602

Show Commands
Page 602 7210 SAS-X, R6 OS Services Guide
Sample Output
Sample output for PBB Epipe:
*A:7210-SAS>show>service# id 1000 all
===============================================================================
Service Detailed Information
===============================================================================
Service Id : 1000 Vpn Id : 0
Service Type : Epipe
Description : (Not Specified)
Customer Id : 1
Last Status Change: 04/04/2001 22:18:48
Last Mgmt Change : 04/04/2001 21:28:34
Admin State : Up Oper State : Up
MTU : n/a
MTU Check : n/a
Vc Switching : False
SAP Count : 1 SDP Bind Count : 0
Uplink Type: : MPLS
-------------------------------------------------------------------------------
Service Destination Points(SDPs)
-------------------------------------------------------------------------------
No Matching Entries
-------------------------------------------------------------------------------
Service Access Points
-------------------------------------------------------------------------------
-------------------------------------------------------------------------------
SAP 1/1/15:1000
-------------------------------------------------------------------------------
Service Id : 1000
SAP : 1/1/15:1000 Encap : q-tag
Description : (Not Specified)
Admin State : Up Oper State : Up
Flags : None
Last Status Change : 04/04/2001 21:29:23
B-vpls
Displays the B-VPLS ID.
Backbone-dest-MAC
Displays the back bone destination MAC address.
Isid
Displays the ISID number.
Flood
Specifies whether or not the traffic is flooded in the B-VPLS for the
Destination instead of unicast. If the backbone destination MAC is in
theB-VPLS FDB, then it will be unicast.
Oper-dest-MAC
Displays the operational destination MAC address.
i-Vpls Count
Displays the count of I-VPLS bound to B-VPLS.
b-Vpls Status
Displays the operational state of the B-VPLS service.
Epipe Count
Displays the count of Epipe bound to B-VPLS.
Label Description