VPRN Service Configuration Commands
Page 782 7210 SAS-X OS Services Guide
ike-policy
Syntax ike-policy ike-policy-id
no ike-policy
Context config>service>vprn>if>sap>ipsec-gw
Description This command configures the IKE policy for the gateway.
Parameters ike-policy-id — Specifies the IKE policy ID.
Values 1 — 2048
local-gateway-address
Syntax local-gateway-address ip-address
no local-gateway-address
Context config>service>vprn>if>sap>ipsec-gw
Description This command configures the ipsec-gateway local address.
Parameters ip-address — Specifies the IP unicast address.
pre-shared-key
Syntax pre-shared-key key
no pre-shared-key
Context config>service>vprn>if>sap>ipsec-gw
Description This command specifies the shared secret between the two peers forming the tunnel.
Parameters key — Specifies a pre-shared-key for dynamic-keying.
multi-service-site
Syntax multi-service-site customer-site-name
no multi-service-site customer-site-name
Context config>service>vprn>if>sap
config>service>vprn>sub-if>grp-if>sap
Description This command creates a new customer site or edits an existing customer site with the customer-site-
name parameter. A customer site is an anchor point to create an ingress and egress virtual scheduler
hierarchy. When scheduler policies are defined for ingress and egress, the scheduler names contained
in each policy are created according to the parameters defined in the policy. Multi-service customer
To Next Page
Loading...
