Virtual Private Routed Network Services
7210 SAS-X OS Services Guide Page 843
Parameters id — Specifies the OSPF VPN domain in the “xxxx.xxxx.xxxx” format. This is exchanged using BGP
in the extended community attribute associated with a prefix. This object applies to VPRN
instances of OSPF only.
type — Specifies the type of the extended community attribute exchanged using BGP to carry the
OSPF VPN domain ID.
Values 0005, 0105, 0205, 8005
vpn-tag
Syntax vpn-tag vpn-tag
no vpn-tag
Context config>service>vprn>ospf
Description This command specifies the route tag for an OSPF VPN on a PE router. This field is set in the tag
field of the OSPF external LSAs generated by the PE. This is mainly used to prevent routing loops.
This applies to VPRN instances of OSPF only. An attempt to modify the value of this object will
result in an inconsistent value error when is not a VPRN instance.
Default vpn-tag 0
lsa-arrival
Syntax lsa-arrival lsa-arrival-time
no lsa-arrival
Context config>service>vprn>ospf>timers
Description This parameter defines the minimum delay that must pass between receipt of the same Link State
Advertisements (LSAs) arriving from neighbors. It is recommended that the neighbors configured
(lsa-generate) lsa-second-wait interval is equal or greater then the lsa-arrival timer configured here.
Use the no form of this command to return to the default.
Default no lsa-arrival
Parameters lsa-arrival-time — Specifies the timer in milliseconds. Values entered that do not match this
requirement will be rejected.
Values 0 — 600000
To Next Page
Loading...
