VPRN Service Configuration Commands
Page 844 7210 SAS-X OS Services Guide
lsa-generate
Syntax lsa-generate max-lsa-wait [lsa-initial-wait [lsa-second-wait]]
no lsa-generate-interval
Context config>service>vprn>ospf>timers
Description This parameter customizes the throttling of OSPF LSA-generation. Timers that determine when to
generate the first, second, and subsequent LSAs can be controlled with this command. Subsequent
LSAs are generated at increasing intervals of the lsa-second-wait timer until a maximum value is
reached. Configuring the lsa-arrival interval to equal or less than the lsa-second-wait interval
configured in the lsa-generate command is recommended.
Use the no form of this command to return to the default.
Default no lsa-generate
Parameters max-lsa-wait — Specifies the maximum interval, in milliseconds, between two consecutive
ocurrences of an LSA being generated.
The timer must be entered as either 1 or in millisecond increments. Values entered that do not
match this requirement will be rejected.
Values 1 — 600000
To Next Page
Loading...
