Show, Clear, Debug Commands
Page 862 7210 SAS-X OS Services Guide
authentication
Syntax authentication
Context show>service>id
Description This command enables the context to display subscriber authentication information.
statistics
Syntax statistics [policy name] [sap sap-id]
Context show>service>id>authentication
Description This command displays session authentication statistics for this service.
Parameters policy name — Specifies the subscriber authentication policy statistics to display.
sap sap-id — Specifies the SAP ID statistics to display. See Common CLI Command Descriptions on
page 925 for command syntax.
If Index
The interface Index assigned by the system. It is used with SNMP IfT-
able.
Virt. If Index
The interface index assigned by the system. It is used with SNMP.
Last Oper Chg
Timestamp associated with the last operational change.
Global If Index
This is the system wide Interface index allotted by the system.
If Type
Network — The IP interface is a network/core IP interface.
Service — The IP interface is a service IP interface.
SNTP B.Cast
Specifies whether SNTP broadcast client mode is enabled or disabled.
Arp Timeout
Specifies the timeout for an ARP entry learned on the interface.
IP Oper MTU
The actual largest service frame size (in octets) that can be transmitted
through the port to the far-end router, without requiring the packet to
be fragmented.
LdpSyncTimer
Specifies the value used for IGP-LDP synchronization.
Redirects
Specifies the rate for ICMP redirect messages.
Unreachables
Specifies the rate for ICMP unreachable messages.
TTL Expired
Specifies the rate for ICMP TTL messages.
MAC Address
Specifies the 48-bit IEEE 802.3 MAC address.
Label Description
To Next Page
Loading...
