Show, Clear, Debug Commands
Page 866 7210 SAS-X OS Services Guide
sdp:300:1 M(10.20.1.31) TLDP 4462 4462 Up TLDP Down
sdp:500:1 M(10.20.1.50) TLDP 4462 4462 Up TLDP Down
==============================================================================
*A:ALA-12#
statistics
Syntax statistics [sap sap-id]
statistics [sdp sdp-id:vc-id]
statistics [interface interface-name]
Context show>service>id>dhcp
Description Displays DHCP statistics information.
Parameters sap-id — Specifies the physical port identifier portion of the SAP definition. See Common CLI
Command Descriptions on page 973 for command syntax.
sdp-id — The SDP identifier.
Values 1 — 17407
vc-id — The virtual circuit ID on the SDP ID for which to display information.
Values 1 — 4294967295
interface interface-name — Displays information for the specified IP interface.
Show DHCP Statistics Output — The following table describes the output fields for DHCP
statistics.
Label Description
Received Packets
The number of packets received from the DHCP clients.
Transmitted Pack-
ets
The number of packets transmitted to the DHCP clients.
Received Mal-
formed Packets
The number of corrupted/invalid packets received from the DHCP cli-
ents.
Received
Untrusted Packets
The number of untrusted packets received from the DHCP clients. In
this case, a frame is dropped due to the client sending a DHCP packet
with Option 82 filled in before “trust” is set under the DHCP interface
command.
Client Packets
Discarded
The number of packets received from the DHCP clients that were dis-
carded.
Client Packets
Relayed
The number of packets received from the DHCP clients that were for-
warded.
Client Packets
Snooped
The number of packets received from the DHCP clients that were
snooped.
To Next Page