MPLS and RSVP
7450 ESS MPLS Guide Page 171
Configuring MPLS and RSVP with CLI
This section provides information to configure MPLS and RSVP using the command line
interface.
Topics in this section include:
• MPLS Configuration Overview on page 172
→ LSPs on page 172
→ Paths on page 172
→ Router Interface on page 173
→ Choosing the Signaling Protocol on page 173
• Basic MPLS Configuration on page 174
• Common Configuration Tasks on page 175
→ Configuring MPLS Components on page 176
→ Configuring Global MPLS Parameters on page 176
→ Configuring an MPLS Interface on page 177
→ Configuring MPLS Paths on page 178
→ Configuring an MPLS LSP on page 179
→ Configuring Manual Bypass Tunnels on page 181
• Configuring RSVP Parameters on page 183
→ Configuring RSVP Message Pacing Parameters on page 184
→ Configuring Graceful Shutdown on page 185
• MPLS Configuration Management Tasks on page 186
• RSVP Configuration Management Tasks on page 191
To Next Page
Loading...
