GMPLS
7450 ESS MPLS Guide Page 453
Configuration of End-to-End GMPLS Recovery
End-to-end GMPLS recovery is configured at the LSP level using the e2e-protection-type
command, as follows:
config
router
gmpls
lsp gmpls-tunnel-name [gmpls-uni]
to remote-uni-c-gmpls-router-id
e2e-protection-type [unprotected|1toN|sbr]
The protection type names are common to those used in the optical network. The protection
types are as follows:
• unprotected — 0x00
• sbr — Full LSP rerouting; 0x01
The default end-to-end protection type is unprotected.
It is possible to configure segment protection on a path independently of the type of end-to-
end protection that is configured.
To Next Page
Loading...
