GMPLS
7450 ESS MPLS Guide Page 459
GMPLS Command Reference
Command Hierarchies
• LMP Commands on page 459
• GMPLS Commands on page 460
• GMPLS Tunnel Group Commands on page 461
• Show Commands on page 461
• Clear Commands on page 461
• Debug Commands on page 462
• Tools Commands on page 462
LMP Commands
config
— router
— [no] lmp
— gmpls-loopback-address ip-address
—no gmpls-loopback-address
— [no] peer peer-node-id
— [no] control-channel lmp-cc-id
— hello [interval hello-interval] dead-interval hello-dead-interval
— hello interval hello-interval [dead-interval hello-dead-interval]
— peer-interface-address ip-address
— setup-role {active | passive}
— [no] shutdown
— peer-loopback-address ip-address
—no peer-loopback-address
— retransmission-interval milliseconds
— retry-limit limit
—no retry-limit
— [no] te-link te-link-id
— [no] shutdown
— [no] te-link
te-link-id
— [no] data-bearer data-bearer-id
— [no] port port-id
— remote-id remote-id
—no remote-id
— [no] shutdown
— link-name te-link-name
—no link-name
— remote-id remote-id
—no remote-id
— [no] shutdown
— [no] shutdown
To Next Page