MPLS Configuration Management Tasks
Page 186 7450 ESS MPLS Guide
MPLS Configuration Management Tasks
This section discusses the following MPLS configuration management tasks:
• Modifying MPLS Parameters on page 186
• Modifying MPLS Path Parameters on page 188
• Modifying MPLS Static LSP Parameters on page 189
• Deleting an MPLS Interface on page 190
Deleting MPLS
NOTE: In order to remove the MPLS instance, MPLS must be disabled (shutdown) and all
SDP bindings to LSPs removed. If MPLS is not shutdown first, when the no mpls command
is executed, a warning message on the console displays indicating that MPLS is still
administratively up.
When MPLS is shut down, the no mpls command deletes the protocol instance and removes
all configuration parameters for the MPLS instance.
To disable MPLS, use the shutdown command.
To remove MPLS on a router, enter the following command:
CLI Syntax: config>router# no mpls
Modifying MPLS Parameters
NOTE: You must shut down MPLS entities in order to modify parameters. Re-enable (no
shutdown) the entity for the change to take effect.
To Next Page
Loading...
