Page 412 7450 ESS MPLS Guide
Clear Commands
interface
Syntax interface ip-int-name [statistics]
Context clear>router>mpls
Description This command resets or clears statistics for MPLS interfaces.
Parameters ip-int-name — The name of an existing IP interface. If the string contains special characters (#, $,
spaces, etc.), the entire string must be enclosed within double quotes.
statistics — This parameter clears only statistics.
lsp
Syntax lsp lsp-name
Context clear>router>mpls
Description This command resets and restarts an LSP.
Parameters lsp-name — The name of the LSP to clear up to 64 characters in length.
lsp-autobandwidth
Syntax lsp-autobandwidth [lsp-name]
Context clear>router>mpls>lsp
Description This command clears the following counters/timers, as follows:
• The sample count is reset to zero, and the average data rate of the current sample interval is
discarded.
• The adjust count is reset to zero.
• The maximum average data rate is zeroed.
• The overflow count is zeroed.
interface
Syntax interface ip-int-name statistics
Context clear>router>rsvp
Description This command resets or clears statistics for an RSVP interface.
To Next Page
Loading...
