LDP Configuration Management Tasks
Page 634 7450 ESS MPLS Guide
LDP Configuration Management Tasks
This section discusses the following LDP configuration management tasks:
• Disabling LDP on page 634
• Modifying Targeted Session Parameters on page 635
• Modifying Interface Parameters on page 636
• Modifying Interface Parameters on page 636
Disabling LDP
The no ldp command disables the LDP protocol on the router. All parameters revert to the default
settings. LDP must be shut down before it can be disabled.
Use the following command syntax to disable LDP:
CLI Syntax: no ldp
shutdown
To Next Page
Loading...
