MPLS and RSVP
7450 ESS MPLS Guide Page 175
Common Configuration Tasks
This section provides a brief overview of the tasks to configure MPLS and provides the CLI
commands.
The following protocols must be enabled on each participating router.
•MPLS
• RSVP (for RSVP-signaled MPLS only), which is automatically enabled when MPLS
is enabled.
In order for MPLS to run, you must configure at least one MPLS interface in the
config>router>mpls context.
• An interface must be created in the config>router>interface context before it can be
applied to MPLS.
•In the config>router>mpls context, configure path parameters for configuring LSP
parameters. A path specifies some or all hops from ingress to egress. A path can be
used by multiple LSPs.
• When an LSP is created, the egress router must be specified in the to command and at
least one primary or secondary path must be specified. All other statements under the
LSP hierarchy are optional.
To Next Page
Loading...
