MPLS and RSVP
7450 ESS MPLS Guide Page 309
Show Commands
auto-lsp
Syntax auto-lsp [lsp-name] auto-bandwidth
auto-lsp [lsp-name] [status {up|down}] [detail] [to ip-address]
auto-lsp [lsp-name] [status {up|down}] {mesh-p2p | one-hop-p2p} [detail] [to ip-address]
Context show>router>mpls
Parameters lsp-name — Specifies the LSP name.
Values 80 characters max
up|down — Specifies the state.
mesh-p2p|one-hop-p2p — Specifies the auto LSP type.
Sample Output
*A:Dut-C# show router mpls auto-lsp
========================================================================
MPLS Auto-LSP Template
========================================================================
LSP Name Type Fastfail Admin Oper
Config State State
------------------------------------------------------------------------
meshP2pLsp3-10.20.1.6-61441 MeshP2P Yes Up Up
meshP2pLsp2-10.20.1.1-61442 MeshP2P Yes Up Up
meshP2pLsp2-10.20.1.2-61443 MeshP2P Yes Up Up
meshP2pLsp2-10.20.1.4-61444 MeshP2P Yes Up Up
meshP2pLsp2-10.20.1.5-61445 MeshP2P Yes Up Up
meshP2pLsp2-10.20.1.6-61446 MeshP2P Yes Up Up
meshP2pLsp10-10.20.1.1-61447 MeshP2P Yes Up Up
meshP2pLsp10-10.20.1.2-61448 MeshP2P Yes Up Up
bypass-tunnel
Syntax bypass-tunnel [to ip-address] [protected-lsp [lsp-name]] [dynamic | manual | p2mp]
[detail]
Context show>router>mpls
Description If fast reroute is enabled on an LSP and the facility method is selected, instead of creating a separate
LSP for every LSP that is to be backed up, a single LSP is created which serves as a backup for a set
of LSPs. Such an LSP tunnel is called a bypass tunnel.
Parameters ip-address — Specify the IP address of the egress router.
lsp-name — Specify the name of the LSP protected by the bypass tunnel.
To Next Page
Loading...
