GMPLS
7450 ESS MPLS Guide Page 465
GMPLS Configuration Commands
LMP Commands
lmp
Syntax [no] lmp
Context config>router
Description This command creates a context for the configurartion of the Link Management Protocol (LMP) on
the system.
Default no lmp
gmpls-loopback-address
Syntax gmpls-loopback-address ip-address
no gmpls-loopback-address
Context config>router>lmp
Description This command specifies the GMPLS Loopback Address to be used by LMP. A corresponding gmpls-
loopback interface must have been configured for LMP to be enabled.
Default no gmpls-loopback-address
Parameters ip-address — Specifies an IPv4 address.
peer
Syntax [no] peer peer-node-id
Context config>router>lmp
Description This command creates a context to enable the specification of the LMP peer parameters. It also
specifies the LMP peer node. For a GMPLS UNI, this is the UNI-N node at the far end of the IP
control channel for the GMPLS UNI. If the peer loopback address is entered using the peer-
loopback-address command, then this is used as the routable peer address; otherwise the peer-node-
id is assumed to correspond to a routable peer loopback
Default no peer
Parameters peer-node-id — An identifier for the LMP peer node. This may be an IPv4-formatted address or a 32-
bit unsigned integer.
Values a.b.c.d | 1 — 4294967295
To Next Page
Loading...
