Alcatel-Lucent 7450 - GMPLS Commands

Command Hierarchies
Page 460 7450 ESS MPLS Guide
GMPLS Commands
config
— router
— [no] gmpls
— gr-helper-time max-recovery recovery-interval seconds max restart restart-
interval seconds
—no gr-helper-time
— keep-multiplier number
—no keep-multiplier
— [no] lsp lsp-name
— e2e-protection-type protection-type
—no e2e-protection-type
— encoding-type encoding-type
—no encoding-type
— generalized-pid generalized-pid
—no generalized-pid
— retry-limit retry-limit
—no retry-limit
— retry-timer seconds
—no retry-timer
— revert-timer seconds
—no revert-timer
— [no] shutdown
— switching-type switching-type
—no switching-type
— to ip-address
— working-path path-name
—no working-path
— bandwidth signal-type
signal-type
—no bandwidth
— exclude-srlg group-name [group-name ... (up to 5 max)]
—no exclude-srlg [group-name [group-name ... (up to 5 max)]]
— segment-protection-type protection-type
—no segment-protection-type
— [no] shutdown
— lsp-init-retry-timeout seconds
—no lsp-init-retry-timeout
— path path-name
—no path
— [no] shutdown
— hop hop-index node-id node-id [te-link te-link-id] {strict | loose}
—no hop hop-index
— [no] peer peer-node-id
— [no] hello-interval hello-interval
— [no] lsp-hold-timer hold-time
— [no] shutdown
— rapid-retransmit-time
hundred-milliseconds
—no rapid-retransmit-time
— rapid-retry-limit limit
—no rapid-retry-limit
— refresh-time seconds
—no refresh-time
— [no] shutdown
— [no] te-link te-link-id