GMPLS
7450 ESS MPLS Guide Page 475
retry-limit
Syntax retry-limit retry-limit
no retry-limit
Context config>router>gmpls>lsp
Description This optional command specifies the number of attempts software should make to re-establish the
GMPLS LSP after it has failed. After each successful attempt, the counter is reset to zero.
When the specified number is reached, no more attempts are made and the GMPLS LSP path is put
into the shutdown state.
Use the config router gmpls lsp lsp-name no shutdown command to bring up the path after the retry
limit is exceeded.
Default 0 (no limit, retries forever)
Parameters retry-limit — Specifies the number of retries.
Values 0 — 10000
Default 0
retry-timer
Syntax retry-timer seconds
no retry-timer
Context config>router>gmpls>lsp
Description This command configures the time, in seconds, for LSP re-establishment attempts after it has failed.
The retry time is jittered to +/- 25% of its nominal value.
The no form of this command reverts the parameter to the default value.
Default 30
Parameters seconds — Specifies the amount of time, in seconds, between attempts to re-establish the LSP after it
has failed.
Values 0 — 600 seconds
Default 30
revert-timer
Syntax revert-timer seconds
no revert-timer
Context config>router>gmpls>lsp
Description This command configures the time, in seconds, for LSP reversion attempts after it has failed.
The no form of the command reverts the timer to the default value.
To Next Page
Loading...
