Alcatel-Lucent 7450 - Basic MPLS Configuration

Basic MPLS Configuration
Page 174 7450 ESS MPLS Guide
Basic MPLS Configuration
This section provides information to configure MPLS and configuration examples of common
configuration tasks. To enable MPLS, you must configure at least one MPLS interface. The
other MPLS configuration parameters are optional. This follow displays an example of an
MPLS configuration.
ALA-1>config>router>if-attr# info
----------------------------------------------
admin-group "green" 15
admin-group "yellow" value 20
admin-group "red" value 25
----------------------------------------------
A:ALA-1>config>router>mpls# info
------------------------------------------
interface "system"
exit
interface "StaticLabelPop"
admin-group "green"
label-map 50
pop
no shutdown
exit
exit
interface "StaticLabelPop"
label-map 35
swap 36 nexthop 10.10.10.91
no shutdown
exit
exit
path "secondary-path"
no shutdown
exit
path "to-NYC"
hop 1 10.10.10.104 strict
no shutdown
exit
lsp "lsp-to-eastcoast"
to 10.10.10.104
from 10.10.10.103
fast-reroute one-to-one
exit
primary "to-NYC"
exit
secondary "secondary-path"
exit
no shutdown
exit
static-lsp "StaticLabelPush"
to 10.10.11.105
push 60 nexthop 10.10.11.105
no shutdown
exit
no shutdown
----------------------------------------------
A:ALA-1>config>router>mpls#