Configuring IP and MPLS in an Overlay Network to Use a GMPLS LSP
Page 456 7450 ESS MPLS Guide
Configuring IP and MPLS in an Overlay Network to Use a
GMPLS LSP
IP and MPLS is able to use GMPLS LSPs as transport by bringing a numbered or unnumbered
IP interface to an endpoint of one or more gLSPs. This IP interface appears as any other IP
interface bound to a network port. The IP interface is bound to the GMPLS tunnel group by a
GMPLS tunnel group number configured in the port command.
The GMPLS tunnel group number must correspond to a locally configured GMPLS tunnel
group.
The following CLI tree illustrates where the GMPLS tunnel group is referenced.
config
router
interface if-name
address a.b.c.d|ipv6-address
port gmpls-tunnel-group gmpls-tunnel-group-id
To Next Page
Loading...
