Alcatel-Lucent 7450 - Interface Parameters

Label Distribution Protocol
7450 ESS MPLS Guide Page 629
Interface Parameters
Use the following syntax to configure interface parameters:
CLI Syntax: config>router# ldp
interface-parameters
interface ip-int-name [dual stack]
bfd-enable [ipv4][ipv6]
ipv4/ipv6
hello timeout factor
keepalive timeout factor
transport-address {system|interface}
no shutdown
ipv4/ipv6
hello timeout factor
keepalive timeout factor
transport-address {system|interface}
The following example displays an interface parameter configuration example:
A:ALA-1>config>router>ldp# info
----------------------------------------------
...
interface-parameters
interface "to-DUT1" dual-stack
ipv4
hello 240 3
keepalive 240 3
exit
exit
exit
----------------------------------------------
A:ALA-1>config>router>ldp#