Alcatel-Lucent 7450 - Tools Commands

LDP
7450 ESS MPLS Guide Page 801
Tools Commands
fec
Syntax fec vc-type vc-type agi agi
fec p2mp-id identifier root ip-address
fec prefix ip-address[/mask]
fec root ip-address source ip-address group mcast-address [rd rd]
fec vc-type vc-type vc-id vc-id
fec vc-type vc-type agi agi saii-type2 global-id:prefix:ac-id taii-type2 global-id:prefix:ac-id
Context tools>dump>router>ldp
Description This command dumps information for an LDP FEC.
Parameters p2mp-id identifier — Dumps LDP active P2MP identifier bindings information.
Values 0 — 4294967295
root ip-address — Dumps root IP address information.
prefix ip-address[/mask] — Dumps LDP active prefix and mask information.
Values ip-address[/mask]> : ipv4-prefix a.b.c.d
ipv4-prefix-le [0..32]
ipv6-prefix x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x - [0..FFFF]H
d - [0..255]D
ipv6-prefix-le [0..128]
source ip-address — Dumps source IP address information.
group mcast-address — Dumps the group multicast address bindings.
rd rd — Dumps information for the route distinguisher.
Values ip-addr:comm-val| 2byte-asnumber:ext-comm-val| 4byte-asnumber:comm-val
vc-type vc-type — Dumps information for the specified VC type.
Values ethernet, vlan, framerelay, atm-all5, atm-cell, hdlc, ppp, cem, atm-vcc, atm-vpc,
ipipe, atm-vcc-1-1, atm-vpc-1-1, atm-aal5-pdu, fr, cep, e1-satop, t1-satop, e3-satop,
t3-satop, cesopsn, tdmoip, cesopsn-cas, tdmoip-cas, fr-dlci, mirror
vc-id vc-id —
Dumps information for the specified VC-ID.
Values 1 — 4294967295
agi agi — Specifies the Attachment Group identifier TLV associated with this service FEC.
Values <ip-addr:comm-val>|<2byte-asnumber:ext-comm-val>|<4byte-asnumber:comm-
val>
ip-addr - a.b.c.d
comm-val - [0..65535]
2byte-asnumber - [1..65535]