Alcatel-Lucent 7450 - MPLS-TP Show Commands; MPLS-TP Tunnel Configuration; Static MPLS Labels

MPLS-TP Show Commands
Page 94 7450 ESS MPLS Guide
MPLS-TP Show Commands
Static MPLS Labels
The following new commands show the details of the static MPLS labels.
show>router>mpls-labels>label <start-label> [<end-label> [in-use|<label-owner>]]
show>router>mpls-labels>label-range
An example output is as follows:
*A:mlstp-dutA# show router mpls
mpls mpls-labels
*A:mlstp-dutA# show router mpls label
label label-range
*A:7950 XRS-20# show router mpls-labels label-range
=======================================================================
Label Ranges
=======================================================================
Label Type Start Label End Label Aging Available Total
-----------------------------------------------------------------------
Static 32 18431 - 18400 18400
Dynamic 18432 524287 0 505856 505856
Seg-Route 0 0 - 0 505856
=======================================================================
MPLS-TP Tunnel Configuration
These should show the configuration of a given tunnel.
show>router>mpls>tp-lsp
A sample output is as follows:
*A:mlstp-dutA# show router mpls tp-lsp
- tp-lsp [<lsp-name>] [status {up|down}] [from <ip-address>|to <ip-address>]
[detail]
- tp-lsp [<lsp-name>] path [protect|working] [detail]
- tp-lsp [<lsp-name>] protection
<lsp-name> : [32 chars max] - accepts * as wildcard char
<path> : keyword - Display LSP path information.
<protection> : keyword - Display LSP protection information.
<up|down> : keywords - Specify state of the LSP
<ip-address> : a.b.c.d
<detail> : keyword - Display detailed information.
*A:mlstp-dutA# show router mpls tp-lsp
path
protection