Alcatel-Lucent 7450 - Configuration at Mirror Destination Node; Static Route Resolution to a LDP Ipv6 FEC

Static Route Resolution to a LDP IPv6 FEC
Page 612 7450 ESS MPLS Guide
•The sdp-id must match an SDP which uses LDP IPv6 FEC
• Configuring egress-vc-label is optional.
config mirror mirror-dest 10
no spoke-sdp sdp-id:vc-id
spoke-sdp sdp-id:vc-id [create]
egress
vc-label egress-vc-label
Configuration at mirror destination node
Use the following syntax to configure at the mirror destination node. Note that:
•The far-end ip-address command is not supported with LDP IPv6 transport tunnel. The
user must reference a spoke-SDP using a LDP IPv6 SDP coming from mirror source node.
•In the spoke-sdp sdp-id:vc-id command, vc-id should match that of the spoke-sdp
configured in the mirror-destination context at mirror source node.
• Configuring ingress-vc-label is optional; both static and t-ldp are supported.
configure mirror mirror-dest 10 remote-source
far-end ip-address [vc-id vc-id] [ing-svc-label ingress-vc-
label| tldp] [icb]
no far-end ip-address
spoke-sdp sdp-id:vc-id [create]
ingress-vc-label ingress-vc-label
exit
no shutdown
exit
exit
Mirroring and LI will also be supported with PW redundancy feature when the endpoint spoke-
SDP, including the ICB, is using a LDP IPv6 tunnel.
Static Route Resolution to a LDP IPv6 FEC
An LDP IPv6 FEC can be used to resolve a static IPv6 route with an indirect next-hop matching
the FEC prefix. The user configures a resolution filter to specify the LDP tunnel type to be
selected from TTM:
config>router>static-route-entry ip-prefix/prefix-length [mcast]
indirect ip-address
tunnel-next-hop
[no] disallow-igp
resolution {any|disabled|filter}
resolution-filter
no] ldp