GMPLS
7450 ESS MPLS Guide Page 497
Debug Commands
gmpls
Syntax gmpls [lsp lsp-name] [sender sender-address] [endpoint endpoint-address] [tunnel-id
tunnel-id] [lsp-id lsp-id] [peer peer-node-id]
no gmpls
Context debug>router
Description This command enables and configures debugging for GMPLS.
The no form of the command disables debugging for GMPLS.
Parameters lsp-name — Debug all GMPLS instances that contain the specified LSP. 80 characters max.
sender-address — Debug all GMPLS instances that contain the specified sender IP address, in dotted
decimal notation.
Values a.b.c.d
endpoint-address — Debug all GMPLS instances that contain the specified endpoint IP address, in
dotted decimal notation.
Values a.b.c.d
tunnel-id — Debug all GMPLS instances that contain the specified identifier of a tunnel.
Values 0 — 4294967295
lsp-id — Debug all GMPLS instances that contain the specified identifier of an LSP.
Values 1 — 65535
peer-node-id — Debug all GMPLS instances that contain the specified identifier or IP address of a
peer node.
Values 1 — 4294967295 | a.b.c.d
event
Syntax [no] event
Context debug>router>gmpls
Description This command enables and disables debugging for specific GMPLS events.
To Next Page
Loading...
